HOW TO USE WOOL WINDER
A DEVICE FOR WINDING YARN INTO A CORELESS BALL, TYPLCALLY FROM A SKEIN FORM
1.Set spindle into geared base by aligning notches. While holding geared base, turn spindle clockwise to secure.
2.Clamp the ball winder to table or other support using integral clamp. Clamp will work on thicknesses up to 1.4''. Clamp is controlled by turning red knob.
3.Rotate yarn guide so loop end faces upward. Pull it out as far is it will go, locking it into working position as shown.
4.Yarn to be wound should be supported on a swift to allow uniform transfer. Feed end of yarn through yarn guide and secure in notch on top of spindle. Yarn is easily placed through guide by simply wrapping it, in a clockwise direction, around the end coil.
5.Turn handle clockwise, forming the yarn into a ball. Finished ball can be withdrawn from winder by simply pulling off from underside of ball. Yarn from ball can be used by withdrawing from ceenter core or from outer edge.